Infant Incubator H-800

Standard Composition

  • Servo Control Mode: air temp;
  • Instant Parameter Displaying: set temp, air temp, heat power rate;
  • Audible & Visual Alarms: power failure, sensor failure, higher/lower temp, air temperature override, fan failure;
  • Power failure reset memory and self-test function;
  • Hood with dual slope: 4 hand-ports
  • Air servo control
  • set temp, air temp, heat power rate;
  • Power failure reset memory and self-test function



Model H-800-1E

110 / 120 V ac, 50Hz / 60Hz

Model H-800-2E

220 / 240 V ac, 50Hz / 60Hz

Power Input


Refer to IEC60601-1, this equipment belongs to Class, Type BF

Its operation is continuous


Power Alarm

Power Failure: Activates if primary power to the Incubator fails or the power wire is accidentally disconnected from the wall receptacle

Fan Alarm

Fan Failure: Activates if Fan motor malfunctions

Sensor Alarm

Air Sensor Failure: Air Sensor malfunction, refer unit to service

Deviation Alarm

High Air Temperature: Activated if displayed Air Temperature is 15°C above set point

Low Air Temperature: Activated if displayed Air Temperature is 25°C below set point

Over Temperature Alarm

Over Air Temperature: Activated when displayed Air Temperature was approach 38°C in Air Mode

System Alarm

System Failure: Activated if Temperature Control System malfunctions

Temperature Control Range and Correlative Specifications

Air Temperature


Temperature Rise Time


Temperature Variability


Temperature Uniformity


Environment Requirement

Environment Temperature

Operation Temperature Range


Store Temperature Range


Environment Humidity

Operation Humidity Range


Store Humidity Range


Atmospheric Pressure Range




Noise Level Within Hood Environment

≤55dB(Environment noise below 45dB)

Carbon Dioxide (CO2) Level within the Hood

Less than 0.5% when a mixture of CO2 in air is delivered at 750ml/min at a point 10cm above the center of the mattress

Air Velocity Over Mattress

less than 0.3m/s

Infant Bed Max Load


Transfusion Shelf Max Load


Factory Default Settings

Temperature Control Mode Air Temperature Mode

Air Set Temperature: 32°C

Temperature Units:°C


Your Shopping cart